MOUNTING AND WIRING INSTRUCTIONS
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These fixtures
meet all UL specifications.
W-375
082814
Guide d’utilisation
1. Turn off power at circuit box to avoid possible electric shock.
2. Thread mounting screws (A) into mounting bar (B) (see fig. 1) approximately 1/4 inch.
3. Secure mounting bar (B) to outlet box (C) with outlet box screws (D) (if applicable).
4. Identify color coding of fixture wires (see fig. 2).
Instructions d’installation
Appareil d’éclairage pour utilisation intérieure
5. Connect the black wire from the fixture with the black wire (live wire) from the outlet box by wire
connector, and wrap the wire connector with electrical tape for a more secure connection.
6. Connect the white wire from the fixture with the white wire (neutral wire) from the outlet box by
wire connector, and wrap the wire connector with electrical tape for a more secure connection.
7. Partially thread green grounding screw (F) into side hole (G) on mounting bar (B) (see fig.1).
8. Wrap grounding wire from fixture around green grounding screw stem (F) leaving enough excess
wire, then connect the excess grounding wire from the fixture with the grounding wire from outlet
box by wire connector (E) (if applicable), then wrap the wire connector (E) with electrical tape for a
more secure connection.
Owner’s Manual
Indoor Lighting Fixture
Installation Instructions
GARANTIE LIMITÉE DE CINQ ANS
Cet appareil d’éclairage Westinghouse est assorti d’une garantie de 5 ans contre les défauts de matéri-
aux et de fabrication, qui entre en vigueur à partir de la date d’achat. La présente garantie se substitue
à toute autre garantie expresse ou tacite.
9. Tighten green grounding screw (F). Do not over tighten.
10. Tuck wires inside outlet box (C).
Cette garantie ne porte ni sur les dommages survenant suite à une catastrophe naturelle (telle que la
foudre), ni sur la corrosion ou la décoloration des pièces; la garantie ne porte pas sur les dommages
survenant suite à une utilisation anormale, une installation impropre, une surtension de courant élec-
trique ou des actes d’un tiers.
WARRANTY INFORMATION
This Westinghouse Lighting Fixture is warranted against defects in material and workmanship for a
period of Five Years from purchase date. This warranty is in lieu of all other warranties expressed or
implied.
FIXTURE ASSEMBLY INSTRUCTIONS
Warning: This fixture is for indoor use only.
This warranty does not cover acts of nature such as lightning damage, or corrosion and discoloration
of components, nor does it cover damages caused through abuse, improper installation, surges in
electric current, or acts of third parties.
Cette garantie ne porte pas sur les frais de démontage et de réinstallation du ventilateur.
1. Raise canopy (H) to ceiling allowing mounting screws (A) to protrude through key slots (I) in
canopy (H) (see fig. 1).
2. Rotate canopy (H) clockwise until mounting screws (A) lock into narrow portion of key slots (I).
Secure into place with mounting screws (A).
Si ce produit ne fonctionne pas, pour une raison quelconque couverte par cette garantie, contactez-
nous gratuitement au numéro suivant : 1-888-417-6222.
This warranty does not cover costs of removing and re-installing the lighting fixture.
3. Install lamp(s). Do not exceed recommended wattage.
4. Raise glass shade (J) to canopy (H) allowing nipple (K) to protrude through opening.
5. Carefully support glass shade (J) while securing washer (L), hex nut (O), cap (M), and finial (N) to
nipple (K).
If this product fails for any reason covered by this warranty, contact us toll free at 1-888-417-6222.
L’ÉLECTROCUTION POURRAIT CAUSER DE GRAVES BLESSURES PERSONNELLES.
MISE EN GARDE:
Lisez ces instructions et suivez-les exactement comme illustré. En cas de doute, ne commencez
pas l’installation. Consultez un électricien qualifié. Lisez toutes les instructions avant de com-
mencer l’installation. Un câblage approprié est essentiel au bon fonctionnement de cet appareil
d’éclairage. Lorsque vous faites une entaille ou que vous percez un trou dans un mur ou un
plafond, n’endommagez pas les câbles électriques, les canalisations de gaz ou d’eau. Si l’un des
composants de raccordement ou de l’appareil d’éclairage est endommagé, n’installez pas cet
appareil d’éclairage. Retournez-le à l’endroit où vous l’avez acheté.
Convient uniquement aux appareils comportant un avertissement indiquant que l’appareil
d’éclairage est doté d’un fil supportant une chaleur de 75°C ou 90°C. (Ces avertissements se
trouvent sur l’étiquette U.L. et sur l’emballage de l’appareil d’éclairage.)
WARNING: ELECTRICAL SHOCK CAN RESULT IN SERIOUS INJURY.
6. Turn power back on at circuit box.
Read and follow instructions exactly as shown. If instructions are unclear, do not proceed.
Contact a qualified electrician. Read all instructions before beginning. Proper wiring is essen-
tial for safe operation of this fixture. When cutting or drilling into walls or ceilings, do not dam-
age electrical wiring, gas lines, or water lines. If any of the fixture or wiring components are
damaged, do not install fixture. Return to place of purchase.
FIGURE 2.
FIXTURE
WIRES:
Black
FIXTURE
WIRES:
White
FIXTURE
WIRES:
Bare
For fixtures provided with 75° C or 90° C supply wire warning only. (These warnings are pro-
vided on the U.L. label and on the fixture carton.) Risk of fire. Most dwellings built before 1985
have supply wires rated 60° C. Consult a qualified electrician before installing.
NOTE: For fixture employing a grounded convenience outlet. This fixture employs a grounded
type receptacle and is not intended for connection to a two wire ungrounded source of supply.
Copper
(Ground)
NOTA: Pour appareil d’éclairage avec sortie terre. Cet appareil d’éclairage utilise un réceptacle
muni d’un fil de terre et ne doit pas être branché à un bloc d’alimentation à deux fils non mis à
la terre.
HOUSE
WIRES:
Black
HOUSE
WIRES:
White
HOUSE
WIRES:
Bare
LES INSTRUCTIONS D’ASSEMBLAGE DE L’APPAREIL D’ÉCLAIRAGE POUR UTILISATION INTÉRIEURE
ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE
(Hot)
(Neutral)
Copper
(Ground)
Félicitations ! Vous avez acheté un produit de Westinghouse Lighting. Cet appareil d’éclairage a été
conçu pour durer de nombreuses années. Si vous avez des questions ou des commentaires à
Congratulations on your Westinghouse purchase. This fixture has been designed to give you many
com/contact-us.
WARNING
NOTA : Déballez soigneusement l’appareil d’éclairage et les pièces. Assurez-vous que toutes les pièces
y sont avant de mettre l’emballage au rebut (voir fig. 1).
NOTE: Carefully unpack fixture and parts. Make sure all parts are included before discarding any pack-
ing materials (see figure 1).
Turn off electricity to the mounting site before beginning installation.
Mounting instructions must be followed exactly as shown for the fixture to be safely sup-
FIGURE 1.
FIGURE 1.
ported.
GROUND
WIRE
*OUTLET
BOX (C)
FIL DE MISE
A LA TERRE
*BOITE DE SORTIE
DE COURANT (C)
CLEANING AND CARE
To clean, wipe fixture with soft cloth. Clean glass with mild soap. Spray from chemical cleaners can
discolor the finish of fixture. Do not use scouring pads, powders, steel wool or abrasive paper to
clean this fixture.
TROU
LATERAL (G)
SIDE
HOLE (G)
WIRE
CONNECTORS (E)
CONNECTEURS
DE FIL (E)
MOUNTING
BARRE DE
NOTE FOR FIXTURES THAT ARE SOLID BRASS:
BAR (B)
FIXATION (B)
Your hand-crafted, solid brass lighting fixture has been coated with a durable, baked-on acrylic lac-
quer which gives maximum protection against the weather. However, in time the brightness of the
brass will tarnish, giving way to an authentic old-world brass finish. To keep your solid brass fixture
looking new for years to come, regularly apply a good quality, non-abrasive car wax to all metal sur-
faces, giving the fixture an extra protective covering.
GREEN
GROUNDING
SCREW (F)
VIS DE MISE
A LA TERRE
(VERTE) (F)
OUTLET BOX
SCREWS (D)
VIS DE LA BOITE DE
SORTIE DE COURANT (D)
MOUNTING
SCREWS (A)
VIS DE
FIXATION (A)
CANOPY (H)
CHAPEAU (H)
ORDERING PARTS
Keep this manual for future reference, and in case replacement parts are needed. Available parts can
be ordered from place of purchase. Use exact wording from diagrams when ordering parts.
KEY SLOTS (I)
RAINURES (I)
MANCHON
FILETE (K)
NIPPLE (K)
GLASS
SHADE (J)
ABAT-JOUR
EN VERRE (J)
WASHER (L)
HEX NUT (O)
RONDELLE (L)
L’ECROU
HEXAGONAL (O)
CAP (M)
CAPUCHON (M)
Il est possible que le dessin illustré ici ne
ECROU
DECORATIF (N)
FINIAL (N)
soit pas la reproduction exacte de l’appareil
d’éclairage contenu dans la boîte.
Les instructions d’installation demeurent
cependant valables.
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A.
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting. All rights reserved. Made in China
Line art shown may not exactly match the
fixture enclosed. However, the installation
instructions do apply to this fixture.
*NOT SUPPLIED
*NON FOURNI
|